Ni,Cr, and Fe surfaces corroded by molten ZnCl2

Understanding the corrosion of molten ZnCl₂ on metal surfaces is significant for the corrosion protection of metals, sustainable use of molten salts, preparation of ZnO coatings, and so on. In this paper, surfaces of pure Ni, Cr, and Fe corroded by molten ZnCl₂ were investigated. The results show that Ni suffered very slight corrosion, while Cr experienced more serious corrosion than Ni, but lighter corrosion than Fe. The morphology of the corrosion of Cr and Fe, respectively, presented pitting and intergranular corrosion characteristics. Furthermore, nanostructured ZnO coatings were obtained on the surfaces of Ni and Fe, but not on the surface of Cr. The ZnO coating on the Ni surface was doped with a small amount of Zn₅(OH)₈Cl₂, and the ZnO coating on the Fe surface was doped with ZnFe₂O₄ and Zn₂OCl₂. The coatings on the Ni and Fe surfaces had an average thickness of 1.5 and 50 μm, respectively.     

含煤盆地深层“超饱和”煤层气形成条件

中国深层煤层气资源丰富，但总体勘探和认识程度较低，尚未形成较为系统的深层煤层气地质理论。通过解剖分析准噶尔盆地白家海凸起和鄂尔多斯盆地临兴区块深层"超饱和"煤层气井的试气/生产动态，估算原地游离气的含气量，分析了深层"超饱和"煤层气的形成条件。研究表明：①深层"超饱和"煤层气储层中除吸附气外，还含有原地游离气，用常规试气方法可直接获得气流，煤层气的产出不明显依赖于排水降压；②埋藏超过一定深度，在煤阶和温度的综合作用下，煤的吸附能力将随埋深的继续增加而降低，煤层中吸附气的饱和度有增加的趋势，在达到吸附饱和后，出现原地游离气并形成"超饱和"煤层气，盆地深层具有"超饱和"煤层气形成的优势条件；③由于地温梯度和压力梯度的不同，不同盆地"超饱和"煤层气出现的临界深度不同，异常高压和异常高热流可以降低深层"超饱和"煤层气形成的临界深度；④深层"超饱和"煤层气开发具有大大缩短见气时间、充分利用地层能量和累积产水量低等优势，有望成为未来煤层气勘探开发的一个重要领域。     

不同煤阶煤孔隙特征及其吸附能力响应

我国是煤炭资源大国，煤层气储量规模相当可观，但煤储层又具有低孔、低渗的不足，照搬国外或常规石油天然气的开采程序和方法已被证实是走不通的。应结合实际，根据不同地质条件、不同煤阶的开采程序，进行孔隙特征研究。煤孔隙特征、连通性和吸附能力对煤层气开采影响尤为重要，为研究煤孔隙结构特征随煤变质程度的变化关系及其吸附能力的响应特点，采取不同地区不同变质程度煤样，进行压汞测试和等温吸附实验。实验结果表明，煤孔隙度和平均孔径均随变质程度增加呈现降低—升高—降低的趋势；煤中孔隙连通性随煤变质程度增加逐渐变差；随煤变质程度增加，其最大吸附能力也呈现降低—升高—降低的总体趋势。     

强织构铝合金残余应力检测技术研究

在铝合金轧板的残余应力研究中，由于其强烈的轧制织构，无法使用常规的X射线sin2 ψ法进行残余应力分析。以2A97铝锂合金轧制板材为研究对象，使用X射线衍射法测量材料的取向分布函数，结合Ruess、Voigt、Neerfeld-Hill模型，从理论上计算不同假设条件下材料的宏观弹性常数，得到材料表面的宏观残余应力。实验结合盲孔法进行对比验证，结果表明Neerfeld-Hill模型的残余应力分析结果与盲孔法所测结果相互吻合，建立织构材料的宏观残余应力分析方法。     

砖混再生粗骨料混凝土力学性能及工程应用研究

采用城市砖混结构拆除建筑垃圾加工制成的再生粗骨料,用不同配合比设计方法制备了砖混再生粗骨料混凝土,研究了砖混再生粗骨料对混凝土工作性、抗压强度、弹性模量、峰值应力、峰值应变以及应力应变关系的影响.结果 表明,相比较天然骨料和废弃混凝土制备的再生骨料,砖混再生骨料空隙率大,吸水率大,压碎指标高.使用附加用水量配合比方法制备的砖混再生粗骨料混凝土在力学性能上低于标准配合比方法制备的砖混再生粗骨料混凝土,但工作性能较好.随着砖混再生粗骨料取代率的增加,再生混凝土的力学性能呈现不同程度的降低.当取代率为100％时,使用标准配合比和附加用水量方法制备的再生混凝土28 d抗压强度分别降低了26.1％和11.9％,弹性模量分别降低了23.9％和22.9％,峰值应力分别降低了13.0％和21.9％,峰值应变分别增大了25.3％和14.9％.工程实践表明,采用砖混再生粗骨料配制的再生混凝土可以满足中低强度等级泵送混凝土的性能要求.     

Application of Mono‐ and Disaccharides in Drug Targeting and Efficacy

Carbohydrates and their conjugates play important roles in many biological processes including fertilization, differentiation, development, immune response, and infection. Their activities are largely dependent on the properties of terminal mono‐ or disaccharides. Galactose, mannose, fucose, glucose, sialic acid, etc., are commonly used as powerful scaffolds installed on drug molecules for targeting specific tissues including brain, liver, and cancers, and as epitopes for enhancing the targeting of various vaccines. This review focuses on the influence of their structural variations, including changes in sugar type, substituent groups and their positions, as well as length of linker portion, on the targeting of drugs or their efficacy. Particular attention is paid to the targeting properties of mono‐ and disaccharides applied in drug design and discovery.     

0Cr20Mn21Ni2N奥氏体不锈钢锻件组织性能研究

研究了无磁钻铤用0Cr20Mn21Ni2N奥氏体不锈钢圆棒锻件横截面的室温强度、硬度和韧性等力学性能,并从微观角度进行了分析。在圆棒表层区域观察到了锻造变形态晶粒组织,而直径四分之一区域为再结晶组织,平均晶粒尺寸为80μm,芯部再结晶晶粒尺寸粗化为150μm,这些差异是由不同的变形温度和降温速度造成的。这种组织差异导致的室温拉伸性能和冲击韧性也有相应的变化趋势。研究结果表明,在900、1000℃以0.5 s-1的应变速率压缩的0Cr20Mn21Ni2N试验钢样品,其应力应变曲线具有一定的加工硬化特征,其芯部硬度比应变速率为0.1 s-1的样品分别提升了28、15 HB。在700、800℃以20%以上的变形量进行压缩时,峰值抗力显著提高,而在900、1000℃以10%~50%的变形量进行压缩时,峰值抗力均无明显提高,可保证顺利的变形过程。     

Enhanced piezoelectric strain of BiFeO3–Ba(Zr0.02Ti0.98)O3 lead-free ceramics near the phase boundary

The xBiFeO₃-(1-x)Ba(Zr_0.02Ti_0.98)O₃ + 1.0 mol% MnO₂ (xBF-BZT) lead-free piezoelectric ceramics were prepared by conventional solid-state reaction method. The structure, dielectric, and piezoelectric properties were studied. X-ray diffraction (XRD) analysis showed that xBF-BZT ceramics exhibited pure perovskite structure with the coexistence of tetragonal and rhombohedral phases (0.66 ≤ x ≤ 0.74). The Curie temperature T_c, the dielectric constant ε_r (1 kHz), dielectric loss tanδ (1 kHz), piezoelectric constant d₃₃, coercive field E_c (80 kV/cm), and remnant polarization P_r (80 kV/cm) of 0.7BF-0.3BZT-Mn ceramics were 491°C, 633, 0.044, 165 pC/N, 35.6 kV/cm, and 22.6 μC/cm², respectively. The unipolar strain of 0.7BF-0.3BZT reached up to 0.20% under the electric field of 60 kV/cm, which is larger than that (0.15%) of BiFeO₃–BaTiO₃ ceramics. These results indicated that the xBF-BZT ceramics were promising candidates for high-temperature piezoelectric materials.     

铝合金热轧板锭熔铸技术及设备

本文概述了近年来铝合金热轧板锭的熔铸设备和熔铸技术的发展和最新成就，重点介绍晶粒细化、熔体净化、检测及铸造新技术，为国内铝板带企业跟踪国际铝合金板锭熔铸技术、开展技术攻关和进行技术创新提供有益的参考。     

解决营口市水资源短缺的主要途径

通过辽宁省第二次水资源评价,对营口市的水资源现状进行了初步分析,并对水资源短缺提出了解决的途径。